Talk Battery/Loop Boosting Power Supply (Model PS-2R)

NEW
The PS-2R will boost both talk battery and loop current on analog single line extensions behind PABX's and key systems. This is helpful for powering line powered devices such as dialers and emergency phones.
Boost Talk Battery and Loop Current to Line Powered Telecom Devices
The PS-2R will boost talk battery and loop current on single analog line extensions behind PABX’s and electronic key systems. This is helpful for powering line powered devices, such as dialers and emergency phones, on low loop current extensions.
Applications
  • Run line powered devices such as handsfree phones, Hot-Line dialers, digital announcers, etc.
  • Increase maximum loop length on analog PABX/KSU stations
Features
  • Regulated 9V DC output
  • Boosts talk battery and loop current
  • UL listed
Specifications
  • Power: 120V AC/9V DC 800 ma power supply
  • Dimensions: 572mm x 572mm x 699mm (2.25" x 2.25" x2.75")
  • Shipping Weight: .45 Kg (1 lb.)
  • Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% non-condensing humidity
  • Connections: (1) pair of wires
Power Viking Products from 12VDC
The PI-150W converts 12 Volts DC to 115 Volts AC with a maximum continuous output power of 150 Watts. The PI-150W will allow you to power Viking products or other 115V AC equipment of less than 150 watts from your vehicle, boat, RV, solar panel or other available 12V DC source.

The PI-150W is equipped with a lighted power switch, power input fuse, low battery alarm and low battery automatic shut down, allowing you to restart your vehicle as well as preventing you from deep-cycling your battery.

Applications
  • Powering Viking model DLE-200B or DLE-300 for emergency or off site communications
  • Powering Viking doorboxes from 12V DCsolar panels
  • Powering any 115V AC equipment of less than150 watts from 11 to 15V DC
Features
  • 150 Watt continuous / 300 Watt surge output power
  • Male cigarette lighter plug
  • Single power receptacle with ground
  • Lighted output power switch
  • Low battery voltage alarm
  • Automatic low battery voltage shut down
  • Automatic thermal overload shut down
  • 30 Amp input fuse
  • High efficiency/ low operating current
  • 1 year limited warranty
Specifications
  • Dimensions: 145mm x 69mm x 41mm (5.7" x 2.7" x 1.6")
  • Shipping Weight: 0.57 kg (1.25 lbs)
  • Environmental: -26° C to 54° C (-15° F to 130° F) with 5% to 95% non-condensing humidity
  • Maximum Current Draw with 12V Supply and 150 watt load: Approximately 13 Amps
  • Input Voltage: 11 to 15V DC
  • Output Voltage: 115V AC RMS (modified sinewave)
  • Output Frequency: 60 Hz +/- 1 %
  • Output Power: 150 Watts continuous / 300 watts peak
  • No Load Current Draw: 200mA
  • Low Battery Alarm: 10.4V +/-0.5V DC
  • Low Battery Shut Down: 9.7V +/- 0.5 V DC
  • Efficiency: 90% at 75 Watts
  • DC Input Fuse: 30A